<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: Share Disk Free Sensor

LanmanServer service

This sensor requires that the LanmanServer service runs on the target system.

The display name of the service is Server.

To enable the service, log in to the respective system and open the services manager (for example, via services.msc). In the list, find the respective service and set its Start Type to Automatic.

Quotas

This sensor only works if no quotas are enabled on the target share. If there are quotas enabled for the user account that this sensor uses to connect to the share, the absolute value is okay, but the percentage variable shows incorrect values.

Share name

You can only enter a share name, for example, C$. Do not enter a complete Universal Naming Convention (UNC) name. The sensor takes the server name \\server\ from the parent device.

IPv6

This sensor supports IPv6.

Performance impact

This sensor has a medium performance impact.

Knowledge Base

Knowledge Base: What can I do if PRTG doesn't succeed with monitoring a share? PE029 PE032

Hosted probe

You cannot add this sensor to the hosted probe of a PRTG Hosted Monitor instance. If you want to use this sensor, add it to a remote probe device.

Share

The name of the share that this sensor monitors.

Primary Channel

Select a channel from the list to define it as the primary channel. In the device tree, PRTG displays the last value of the primary channel below the sensor's name. The available options depend on what channels are available for this sensor.

You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab.

Graph Type

Define how this sensor shows different channels:

• Show channels independently (default): Show a graph for each channel.
• Stack channels on top of each other: Stack channels on top of each other to create a multi-channel graph. This generates a graph that visualizes the different components of your total traffic.
  You cannot use this option in combination with manual Vertical Axis Scaling (available in the channel settings).

Stack Unit

This setting is only visible if you select Stack channels on top of each other above.

Select a unit from the list. PRTG stacks all channels with this unit on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so.

Downtime

In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down status.

Free Bytes

The free space

Free Space

The free space (%)

This channel is the primary channel by default.