<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: SNMP APC Hardware Sensor

IPv6

This sensor supports IPv6.

Performance impact

This sensor has a very low performance impact.

Knowledge Base

• Knowledge Base: How can I monitor additional counters with the SNMP APC Hardware sensor?
• Knowledge Base: How can I monitor an APC UPS that does not support SNMP?

Category

Select the performance counters that you want to monitor. PRTG creates one SNMP Custom Advanced sensor with all performance counters of each category that you select.

Interface

TheSe name of the interface (performance counter) that this sensor monitors.

Unit String

Define the unit of the numeric data that this sensor monitors at the OID. Enter a string.

Multiplication

If you want to multiply the received data with a certain value, enter the multiplier. Use the default value 1 to not change the received value. Enter an integer.

Division

If you want to divide the received data by a certain value, enter the divisor. Use the default value 1 to not change the received value. Enter an integer.

If Value Changes

Define what the sensor does when its value changes:

• Ignore (default): Do nothing.
• Trigger 'change' notification: Send an internal message that indicates a change.
  In combination with a change trigger, you can use this to trigger a notification if a change occurs.

Primary Channel

Select a channel from the list to define it as the primary channel. In the device tree, PRTG displays the last value of the primary channel below the sensor's name. The available options depend on what channels are available for this sensor.

You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab.

Graph Type

Define how this sensor shows different channels:

• Show channels independently (default): Show a graph for each channel.
• Stack channels on top of each other: Stack channels on top of each other to create a multi-channel graph. This generates a graph that visualizes the different components of your total traffic.
  You cannot use this option in combination with manual Vertical Axis Scaling (available in the channel settings).

Stack Unit

This setting is only visible if you select Stack channels on top of each other above.

Select a unit from the list. PRTG stacks all channels with this unit on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so.

Downtime

In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down status.

[Performance Counter]

The performance counters on an APC UPS device

• Actual voltage of battery
• Capacity of battery
• Input and output frequency
• Input and output voltage
• Output load
• Remaining runtime of battery
• Temperature of battery