<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: SNMP NetApp Network Interface Sensor

NetApp versions

This sensor only supports NetApp versions up to 8.2.

IPv6

This sensor supports IPv6.

Performance impact

This sensor has a low performance impact.

NetApp NIC

If you use NetApp cDOT 8.3 or NetApp ONTAP as of version 9.0, we recommend that you use the NetApp NIC sensor.

Network Interface

The name of the network interface that this sensor monitors.

Primary Channel

Select a channel from the list to define it as the primary channel. In the device tree, PRTG displays the last value of the primary channel below the sensor's name. The available options depend on what channels are available for this sensor.

You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab.

Graph Type

Define how this sensor shows different channels:

• Show channels independently (default): Show a graph for each channel.
• Stack channels on top of each other: Stack channels on top of each other to create a multi-channel graph. This generates a graph that visualizes the different components of your total traffic.
  You cannot use this option in combination with manual Vertical Axis Scaling (available in the channel settings).

Stack Unit

This setting is only visible if you select Stack channels on top of each other above.

Select a unit from the list. PRTG stacks all channels with this unit on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so.

Downtime

In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down status.

Errors In

The number of incoming errors

Errors Out

The number of outgoing errors

Traffic In

The incoming traffic

This channel is the primary channel by default.

Traffic Out

The outgoing traffic